epitalon comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Updated 2025-11-07. Numbers and descriptions here follow the published literature rather than marketing material.
Epitalon is a synthetic four-amino-acid peptide with the sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9, and its calculated molar mass is approximately 390.35 grams per mole. The compound is a short fragment related to a peptide fraction isolated from bovine pineal gland extracts, and it is normally supplied as a lyophilised powder intended for laboratory research. It is not a registered pharmaceutical product in most countries.
The peptide emerged from research carried out in Saint Petersburg from the late 1980s onward, where investigators searched for shorter active fragments of a pineal preparation known as epithalamin. The name epitalon was chosen to reflect that parent extract. Early reports described effects on neuroendocrine markers and on the lifespan of laboratory animals. Much of that work appeared in Russian-language journals, with English translations following later, which affects how readily the original protocols can be assessed by outside groups.
Published studies on epitalon are dominated by a small number of research groups, and independent replication in other laboratories remains limited. Proposed mechanisms include activation of telomerase and modulation of melatonin rhythms, but the evidence for either rests mainly on cell cultures and animal models. Whether the peptide produces comparable effects in humans is an open question, and the absence of large controlled trials means the literature is best read as exploratory rather than settled.
Short peptides such as AEDG are normally supplied as a freeze-dried solid and are kept dry, cold, and shielded from light. Holding at minus twenty degrees Celsius is common for the long term, while a refrigerator suffices for brief periods before use. The material takes up moisture to some degree, so containers should stay sealed and be allowed to reach room temperature before opening, which limits condensation on the contents. Repeated warming and cooling of a single container is discouraged because it admits water and can lower the amount of intact peptide.
Dissolution is usually performed in water or a suitable aqueous buffer, and the resulting liquid is divided into single-use portions before freezing. Freeze-thaw cycling is a recognised source of loss for short peptides, since each cycle can encourage aggregation or adsorption onto container walls. Working solutions are generally kept cold and used within a short window, although published stability data specific to epitalon are thin. Containers should be marked with concentration and date, and solutions examined for cloudiness before use.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C14H22N4O9 | Derived from the four-residue sequence |
| Molar mass | About 390.35 g/mol | Free peptide, counter-ion not included |
| Appearance | White to off-white powder | Lyophilised solid from aqueous solution |
| Water solubility | Freely soluble | Short, polar peptide chain |
| Common synonyms | AEDG; epithalone | Catalogues use the names interchangeably |
Epitalon is the common name for a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, usually abbreviated AEDG. All four residues are proteinogenic amino acids, and the free peptide has a calculated mass near 390 grams per mole. Because the chain is short and carries no modifications, it is assembled readily by solid-phase synthesis and is distributed mainly as a freeze-dried solid for laboratory work. Catalogue listings use the spellings epitalon, epithalone, and simply AEDG, and the three refer to the same sequence.
The compound is generally presented as a synthetic fragment of epithalamin, a pineal gland extract investigated in the former Soviet Union from the 1970s onward. Vladimir Khavinson and colleagues in Saint Petersburg developed short peptides modelled on such extracts, and epitalon became the most widely cited of those sequences. Most primary reports appeared in Russian-language journals or in proceedings with limited international circulation. Independent replication in laboratories outside that network remains sparse, and much repeated secondary material traces back to a small number of originating groups.
Solubility is high in water, phosphate-buffered saline and normal saline, a pattern that follows from the two acidic residues in the chain. The peptide dissolves poorly in non-polar solvents such as hexane or chloroform. Stock solutions are often prepared in water first and then diluted into the buffer of interest. Because the molecule is small and hydrophilic, filtration through a low-protein-binding membrane is usually straightforward, and visible particulates are uncommon in freshly made solutions.
Identity and purity are established with reversed-phase high-performance liquid chromatography and mass spectrometry. The chromatogram shows the main peak and any truncated or oxidised by-products, while the mass spectrum confirms the expected 390 dalton mass. Amino acid analysis can corroborate composition when a sample's origin is uncertain. Counterion content, particularly residual trifluoroacetate from purification, is frequently reported alongside purity because it shifts the net mass of the solid.
Epitalon is a synthetic tetrapeptide whose four residues are alanine, glutamate, aspartate and glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9 and its monoisotopic mass is near 390.35 daltons. The peptide carries two acidic side chains, so it is neutral to negatively charged in most aqueous buffers. Published reference summaries usually list it under both spellings, epitalon and epithalon, and treat the two names as the same material.
The compound is generally described as a synthetic analogue of a fragment isolated from a pineal gland extract. Researchers associated with the Saint Petersburg Institute of Bioregulation and Gerontology introduced it during the 1980s and 1990s while studying short peptides from animal tissue. The original extract, called epithalamin, is a heterogeneous mixture, whereas epitalon is a single defined sequence. That distinction matters because findings reported for the extract are not automatically findings about the pure tetrapeptide, and claims about broader biological effects remain a separate question from the chemical identity described here.
Residue composition is the property that most cleanly separates verified material from mislabelled samples. Alanine, glutamate, aspartate and glycine appear in that order from the N-terminus, and the two acidic residues sit in the middle of the chain. Because the peptide is short, it can be produced by solid-phase synthesis and characterised by mass spectrometry without ambiguity. Any reported sample whose measured mass departs substantially from 390 daltons is a different compound or a degraded mixture rather than epitalon.
== Mechanism == After iterative computational and experimental studies, the internal amidate mechanism was proposed in collaboration of Wu, Yu, and Houk. In the proposed mechanism, the trimeric Pd-precatalyst converts to the mono-Pd complex with coordination to solvent and the bidentate MPAA ligand. Mass spectrometry results reveal this active catalyst which forms favorably with the stabilizing dianionic MPAA ligand as computations suggest.
In genetics, the Ka/Ks ratio, also known as ω or dN/dS ratio, is used to estimate the balance between neutral mutations, purifying selection and beneficial mutations acting on a set of homologous protein-coding genes. It is calculated as the ratio of the number of nonsynonymous substitutions per non-synonymous site (Ka), in a given period of time, to the number of synonymous substitutions per synonymous site (Ks), in the same period. The latter are assumed to be neutral, so that the ratio indicates the net balance between deleterious and beneficial mutations. Values of Ka/Ks significantly above 1 are unlikely to occur without at least some of the mutations being advantageous. If beneficial mutations are assumed to make little contribution, then Ka/Ks estimates the degree of evolutionary constraint.
These names were later suggested for element 114 (flerovium) and element 116 (moscovium). Flerovium became the name of element 114; the final name proposed for element 116 was instead livermorium, with moscovium later being proposed and accepted for element 115 instead. Traditionally, the names of all noble gases end in "-on", with the exception of helium, which was not known to be a noble gas when discovered. The IUPAC guidelines valid at the moment of the discovery approval however required all new elements be named with the ending "-ium", even if they turned out to be halogens (traditionally ending in "-ine") or noble gases (traditionally ending in "-on"). While the provisional name ununoctium followed this convention, a new IUPAC recommendation published in 2016 recommended using the "-on" ending for new group 18 elements, regardless of whether they turn out to have the chemical properties of a noble gas. The scientists involved in the discovery of element 118, as well as those of 117 and 115, held a conference call on 23 March 2016 to decide their names. Element 118 was the last to be decided upon; after Oganessian was asked to leave the call, the remaining scientists unanimously decided to have the element "oganesson" after him. Oganessian was a pioneer in superheavy element research for sixty years reaching back to the field's foundation: his team and his proposed techniques had led directly to the synthesis of elements 107 through 118.
Sources: en.wikipedia.org
=== Spread === Following the Spanish conquest of the Inca Empire, the Spanish introduced the potato to Europe in the second half of the 16th century as part of the Columbian exchange. The staple was subsequently conveyed by European mariners (possibly including the Russian-American Company) to territories and ports throughout the world, especially their colonies. European and colonial farmers were slow to adopt farming potatoes. After 1750, they became an important food staple and field crop and played a major role in the European 19th century population boom. According to conservative estimates, the introduction of the potato was responsible for a quarter of the growth in Old World population and urbanization between 1700 and 1900. Lack of genetic diversity, due to the very limited number of varieties initially introduced, left the crop vulnerable to disease. In 1845, a plant disease known as late blight, caused by the fungus-like oomycete Phytophthora infestans, spread rapidly through the poorer communities of western Ireland as well as parts of the Scottish Highlands, resulting in the crop failures that led to the Great Irish Famine. The International Potato Center, based in Lima, Peru, holds 4,870 types of potato germplasm, most of which are traditional landrace cultivars. In 2009, a draft sequence of the potato genome was made, containing 12 chromosomes and 860 million base pairs, making it a medium-sized plant genome. It had been thought that most potato cultivars derived from a single origin in southern Peru and extreme Northwestern Bolivia, from a species in the S.
Methylthioninium chloride, commonly called methylene blue, is a salt used as a dye and as a medication. As a medication, it is mainly used to treat methemoglobinemia. It has previously been used for treating cyanide poisoning and urinary tract infections, but this use is no longer recommended. It has also been used to treat cases of malaria for over a century. Methylene blue is typically given by injection into a vein. Common side effects include headache, nausea, and vomiting. Methylene blue was first prepared in 1876, by Heinrich Caro. It is on the World Health Organization's List of Essential Medicines. In recent years, methylene blue has been promoted for various health effects, but outside its established medical use, its safety and effectiveness are unproven; it is potentially toxic and should only be used under a doctor's prescription.
== Recombinant protein design == The earliest applications of recombinant protein design can be documented in the use of single peptide tags for purification of proteins in affinity chromatography. Since then, a variety of fusion protein design techniques have been developed for applications as diverse as fluorescent protein tags to recombinant fusion protein drugs. Three commonly used design techniques include tandem fusion, domain insertion, and post-translational conjugation.
Sources: en.wikipedia.org
It is a synthetic tetrapeptide built from alanine, glutamate, aspartate and glycine. The four residues are joined by standard peptide bonds, giving a linear chain rather than a branched structure.
The name derives from epithalamin, a pineal gland extract studied in the former Soviet Union. Researchers proposed that short fragments of that extract carried the biological activity of interest.
No major regulatory agency has approved it as a medicine. It is handled as a research chemical, and products sold under this name are not standardised drugs with defined clinical labelling.
Reversed-phase high-performance liquid chromatography is run alongside mass spectrometry. The chromatogram separates components and gives a purity figure, while the mass spectrum confirms that the measured molecular mass matches the expected sequence. Neither measurement on its own is treated as sufficient.