tetrapeptide comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Last reviewed on 2026-01-02. Where a claim depends on a specific study, the study is described rather than over-claimed.
Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.
Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and its calculated monoisotopic mass is approximately 390.35 daltons. The compound does not occur naturally as a free peptide; it is produced by solid-phase peptide synthesis. Because it contains two acidic residues and no basic residues, the neutral form carries a net negative charge at physiological pH. This charge profile influences how the peptide behaves in solution and during chromatographic analysis.
Reference material is normally supplied as a lyophilised powder in a sealed vial. Product literature typically recommends storage at minus twenty degrees Celsius or colder, protected from light and moisture. Freeze-thaw cycling is usually avoided because repeated condensation can introduce water into the vial. Working solutions are commonly prepared fresh, aliquoted, and kept cold for short periods rather than stored at ambient temperature. Labelling the date of opening helps track how long a vial has been in use.
Solubility is high in water, phosphate-buffered saline and normal saline, a pattern that follows from the two acidic residues in the chain. The peptide dissolves poorly in non-polar solvents such as hexane or chloroform. Stock solutions are often prepared in water first and then diluted into the buffer of interest. Because the molecule is small and hydrophilic, filtration through a low-protein-binding membrane is usually straightforward, and visible particulates are uncommon in freshly made solutions.
Identity and purity are established with reversed-phase high-performance liquid chromatography and mass spectrometry. The chromatogram shows the main peak and any truncated or oxidised by-products, while the mass spectrum confirms the expected 390 dalton mass. Amino acid analysis can corroborate composition when a sample's origin is uncertain. Counterion content, particularly residual trifluoroacetate from purification, is frequently reported alongside purity because it shifts the net mass of the solid.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C14H22N4O9 | Free acid form of the tetrapeptide |
| Molecular mass | About 390.35 Da | Calculated monoisotopic value |
| Appearance | White to off-white powder | Typical lyophilized presentation |
| Solubility | Soluble in water | Also dissolves in buffered saline |
| Storage temperature | Minus 20 degrees Celsius | Dry, dark conditions; avoid repeated thawing |
The four residues give epitalon a molecular formula of C14H22N4O9 and a molecular weight near 390.35 daltons. The presence of two acidic residues, glutamate and aspartate, makes the free peptide strongly acidic, while the alanine and glycine ends provide neutral, nonpolar character. This combination produces a molecule with substantial water solubility. Because there are no cysteine, methionine, or tryptophan residues, the peptide lacks the most common oxidation-sensitive side chains, which simplifies handling compared with many longer peptides.
The proposed relationship between epitalon and pineal function is a central part of its background. Khavinson's group reported that short peptides corresponding to regions of larger pineal proteins could influence gene expression in cells. Epitalon was framed as a synthetic analogue of an active fragment rather than a direct isolation product. Whether the tetrapeptide reproduces the effects of the parent extract is an open question, because comparative studies are limited and the parent extract itself is not a single defined substance.
Interest in epitalon is usually discussed within the broader field of short peptide bioregulators, a category that includes other synthetic di-, tri-, and tetrapeptides studied by the same research group. These compounds share a common rationale: that small fragments of tissue-derived proteins can retain biological activity and can be produced reproducibly. The category as a whole remains outside mainstream pharmacological consensus, and epitalon specifically has a limited presence in independent, non-Russian research literature, which shapes how its evidence base is described.
The molecule is a short, linear, hydrophilic peptide that dissolves readily in water or aqueous buffer. Its principal chemical liabilities are hydrolytic rather than oxidative, since it contains no cysteine, methionine, or tryptophan residues. The aspartate–glycine step is a recognised site for aspartimide formation under mildly acidic or basic conditions, generating isoaspartate and succinimide-related products over time. Desiccated lyophilised powder held at −20 °C is comparatively stable, whereas dilute solutions degrade faster and are best frozen as single-use aliquots rather than thawed repeatedly.
No pharmacopoeial monograph exists for this peptide, so quality rests on the supplier's internal specifications and on whatever independent testing a purchaser arranges. Certificates of analysis differ widely in which tests they report and in the limits applied. The counter-ion introduced during purification, commonly acetate or trifluoroacetate, changes the net peptide content of a given mass of powder, so two samples of equal weight may not contain equal amounts of the active sequence. Third-party laboratories can verify purity, identity, residual solvents, and counter-ion content for a fee, which makes documentation more informative than labelling.
Published studies on epitalon are dominated by a small number of research groups, and independent replication in other laboratories remains limited. Proposed mechanisms include activation of telomerase and modulation of melatonin rhythms, but the evidence for either rests mainly on cell cultures and animal models. Whether the peptide produces comparable effects in humans is an open question, and the absence of large controlled trials means the literature is best read as exploratory rather than settled.
Epitalon is a synthetic four-amino-acid peptide with the sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9, and its calculated molar mass is approximately 390.35 grams per mole. The compound is a short fragment related to a peptide fraction isolated from bovine pineal gland extracts, and it is normally supplied as a lyophilised powder intended for laboratory research. It is not a registered pharmaceutical product in most countries.
The peptide emerged from research carried out in Saint Petersburg from the late 1980s onward, where investigators searched for shorter active fragments of a pineal preparation known as epithalamin. The name epitalon was chosen to reflect that parent extract. Early reports described effects on neuroendocrine markers and on the lifespan of laboratory animals. Much of that work appeared in Russian-language journals, with English translations following later, which affects how readily the original protocols can be assessed by outside groups.
It's the only antipsychotic that's demonstrated efficacy as a monotherapy for the treatment of major depressive disorder and bipolar disorder (it treats mixed mood swings alone). It indirectly serves as a norepinephrine reuptake inhibitor by means of its active metabolite, norquetiapine. Zotepine – Of the dibenzothiepin class of atypical antipsychotic indicated for acute and chronic schizophrenia. It is still used in Japan and was once used in Germany but it was discontinued.†
Silica nanoparticles- Silica nanoparticles can be classified into solid, non-porous, and mesoporous. They have large surface are, hydrophilic surface, and chemical and physical stabilities. Silica nanoparticles are made by the use of the Stöber process. Which is the hydrolysis of silyl ethers such as tetraethyl silicate into silanols (Si-OH) using ammonia in a mixture of water and alcohol followed by the condensation of silanols into 50–2000 nm silica particles. The size of the particle can be controlled by varying the concentration of silyl ether and alcohol or the micro emulsion method. Mesoporous silica nanoparticles are synthesized by the sol-gel process. They have pores that range in diameter from 2 nm to 50 nm. They are synthesized in a water-based solution in the presence of a base catalyst and a pore forming agent known as a surfactant. Surfactants are molecules that present the particularity to have a hydrophobic tail (alkyl chain) and a hydrophilic head (charged group, such as a quaternary amine for example). As these surfactants are added to a water-based solution, they will coordinate to form micelles with increasing concentration in order to stabilize the hydrophobic tails. Varying the pH of the solution and composition of the solvents, and the addition of certain swelling agents can control the pore size. Their hydrophilic surface is what makes silica nanoparticles so important and allows them to carry out functions such as drug and gene delivery, bio imaging and therapy.
== Overview of the carbon fixation cycles == Seven autotrophic carbon fixation pathways are known: the Calvin Cycle, the Reverse Krebs Cycle, the reductive acetyl-CoA, the 3-HP bicycle, the 3-HP/4-HB cycle, the DC/4-HB cycles, and the reductive glycine pathway.
Sources: en.wikipedia.org
== Structure == The structure of the inactive μ-opioid receptor has been determined with the antagonists β-FNA and alvimopan. Many structures of the active state are also available, with agonists including DAMGO, β-endorphin, fentanyl and morphine. The structure with the agonist BU72 has the highest resolution, but contains unexplained features that may be experimental artifacts. This large body of evidence has enabled structure-based design of a new class of opioids with functional selectivity.
Carbohydrate intermediates: In carbohydrate metabolism, intermediates such as glucose-6-phosphate and fructose-1,6-bisphosphate appear during glycolysis and gluconeogenesis. Amino acid intermediates: During amino acid biosynthesis or degradation, intermediates such as 2-oxoglutarate, pyruvate, or oxaloacetate are produced. These intermediates also link to the citric acid cycle. Lipid intermediates: Fatty acid metabolism involves intermediates like acyl-CoA derivatives during β-oxidation or fatty acid synthesis. Nucleotide intermediates: The metabolism of nucleotides, the building blocks of DNA and RNA, includes intermediates like inosine monophosphate (IMP), which is part of purine biosynthesis.
=== Polyaspartic acid === Polyaspartic acid, like IDS, binds to calcium and other heavy metal ions. It has many practical applications including corrosion inhibitors, wastewater additives, and agricultural polymers. A polyaspartic acid-based laundry detergent was the first laundry detergent in the world to receive the EU flower ecolabel. Calcium binding ability of polyaspartic acid has been exploited for targeting of drug-loaded nanocarriers to bone. Preparation of hydrogels based on polyaspartic acid, in a variety of physical forms ranging from fiber to particle, can potentially enable facile separation of the chelated ions from a solution. Therefore, despite being weaker than EDTA, polyaspartic acid can still be regarded as a viable alternative due to these features as well as biocompatibility and biodegradability.
Sources: en.wikipedia.org
Epitalon is a synthetic tetrapeptide built from four amino acids: alanine, glutamate, aspartate, and glycine. It is not extracted from a natural source but made in the laboratory by chemical synthesis. Its short length makes it relatively straightforward to produce at high purity.
No naturally occurring free form of the peptide has been described. The four-amino-acid sequence can appear as a fragment within larger proteins, but that is not the same as the intact compound being present as a circulating molecule. Materials used in research are synthetic.
Purity is usually checked by reverse-phase high-performance liquid chromatography, which separates the target peptide from related impurities. Mass spectrometry is commonly used alongside it to confirm molecular mass. Some suppliers also provide amino acid analysis for additional sequence confirmation.
Sealed lyophilised powder is normally kept at minus twenty degrees Celsius or below, away from light and moisture. Vials are allowed to reach room temperature before opening to limit condensation. Repeated warming and cooling of the same vial is discouraged.