A practical reference on AEDG: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2026-02-21 and is reviewed periodically as new material appears.
Solubility is high in water, phosphate-buffered saline and normal saline, a pattern that follows from the two acidic residues in the chain. The peptide dissolves poorly in non-polar solvents such as hexane or chloroform. Stock solutions are often prepared in water first and then diluted into the buffer of interest. Because the molecule is small and hydrophilic, filtration through a low-protein-binding membrane is usually straightforward, and visible particulates are uncommon in freshly made solutions.
Identity and purity are established with reversed-phase high-performance liquid chromatography and mass spectrometry. The chromatogram shows the main peak and any truncated or oxidised by-products, while the mass spectrum confirms the expected 390 dalton mass. Amino acid analysis can corroborate composition when a sample's origin is uncertain. Counterion content, particularly residual trifluoroacetate from purification, is frequently reported alongside purity because it shifts the net mass of the solid.
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and its calculated monoisotopic mass is approximately 390.35 daltons. The compound does not occur naturally as a free peptide; it is produced by solid-phase peptide synthesis. Because it contains two acidic residues and no basic residues, the neutral form carries a net negative charge at physiological pH. This charge profile influences how the peptide behaves in solution and during chromatographic analysis.
Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.
Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilised and often hygroscopic |
| Solubility class | Freely soluble in water | Poor solubility in non-polar solvents |
| Typical storage temperature | -20 degrees Celsius or colder | Sealed, desiccated, protected from light |
| Typical analytical method | Reversed-phase HPLC with mass spectrometry | Establishes purity and confirms mass |
| Common salt form | Trifluoroacetate or acetate | Counterion reported alongside purity values |
Stability depends strongly on pH, temperature and the presence of oxygen and trace metals. Cleavage of the backbone proceeds faster under neutral to alkaline conditions, whereas acidic solutions tend to slow that reaction. The aspartate and glutamate side chains can undergo deamidation or imide formation over time, generating closely related impurities. Published stability data specific to epitalon are sparse, so the usable life of a given solution is best regarded as an open question that depends on buffer composition, concentration and storage temperature.
Identity and purity are usually assessed by reversed-phase high-performance liquid chromatography with ultraviolet detection, frequently near 214 nanometers where the peptide bond absorbs. Mass spectrometry, most often with electrospray ionization, confirms the observed molecular mass and helps separate the intact peptide from truncated or modified forms. Amino acid analysis or tandem mass spectrometry can establish residue order. Purity is commonly quoted as an area percentage, yet such values are method-dependent, and comparisons between laboratories require matching column, gradient and detection wavelength.
Laboratory handling begins with dissolution of the lyophilized powder in water or a suitable aqueous buffer. The dry solid is the more stable form, so stock solutions are generally prepared only when required and kept cold afterwards. Repeated freezing and thawing of a solution is avoided because it encourages aggregation and gradual loss of the intact chain. Diluents and containers are selected to limit adsorption of a short peptide onto plastic surfaces and to reduce microbial growth in aqueous preparations.
Most experimental work has been carried out in cell culture and animal models. Several reports describe changes in telomerase activity and proliferation in cultured cells, while rodent studies have examined lifespan, melatonin rhythm and reproductive endpoints. Human data remain limited, and much of the published clinical material consists of small trials with incomplete reporting of methods and controls. Whether the cell and animal findings translate into measurable effects in people is an open question, and the mechanistic basis of the reported telomerase changes is not fully established.
Discussions in the literature often conflate three distinct entities: the pineal extract epithalamin, the isolated tetrapeptide AEDG, and commercial preparations sold under similar names. Reviews citing older Russian-language studies sometimes omit detail on purity, route of administration and control groups, which makes cross-study comparison difficult. Researchers working with the compound generally note the need for independent replication, standardized enzyme assays, and clearer reporting of peptide identity. These caveats are relevant when weighing claims that appear in secondary sources rather than in primary reports.
（TG:@pojiaai）Epitalon is a synthetic linear tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. It emerged from work on epithalamin, a peptide fraction prepared from bovine pineal tissue, and was designed as a short, chemically defined analogue of that extract. Early publications came mainly from Russian laboratories studying pineal peptides and aging-related endpoints. The compound appears in the literature under several spellings, including epithalon and epithalone, which complicates systematic searching. Its small size makes solid-phase assembly and routine analytical characterization straightforward.
=== Ascites === Salt restriction is often necessary, as cirrhosis leads to the accumulation of salt (sodium retention). Diuretics may be necessary to suppress ascites. Diuretic options for inpatient treatment include aldosterone antagonists (spironolactone) and loop diuretics. Aldosterone antagonists are preferred for people who can take oral medications and do not need an urgent volume reduction. Loop diuretics can be added as additional therapy. Where salt restriction and the use of diuretics are ineffective, then paracentesis may be the preferred option. This procedure requires the insertion of a plastic tube into the peritoneal cavity. Human serum albumin solution is usually given to prevent complications from the rapid volume reduction. In addition to being more rapid than diuretics, 4–5 liters of paracentesis is more successful in comparison to diuretic therapy.
=== Fluorogenic labels === A fluorogen is a ligand (fluorogenic ligand) which is not itself fluorescent, but when it is bound by a specific protein or RNA structure becomes fluorescent. For instance, FAST is a variant of photoactive yellow protein which was engineered to bind chemical mimics of the GFP tripeptide chromophore. Likewise, the spinach aptamer is an engineered RNA sequence which can bind GFP chromophore chemical mimics, thereby conferring conditional and reversible fluorescence on RNA molecules containing the sequence.
In total the Apollo programme involved six crewed Moon landings from 1969 to 1972, and a total of twelve astronauts walked on the surface of the Moon. These were Apollo 11, Apollo 12, Apollo 14, Apollo 15, Apollo 16, and Apollo 17.
Sources: en.wikipedia.org
== The Protein == The 25-kDa core protein (excluding the heavy glycosylation) of rodent Thy-1 is 111 or 112 amino acids in length, and is N-glycosylated at three sites (In contrast to only two glycosylation sites for human Thy-1). The 162aa (murine, 161 for human) Thy1 precursor has 19 amino acid (aa 1–19) signal sequence and 31 amino acid (aa 132–162) C-terminal transmembrane domain that is present in pro form but removed when transferring the 112 amino acid (aa 20–131) mature peptide to GPI anchor which would attach through the aa 131. Some of the common monoclonal antibodies used to detect this protein are clones OX7, 5E10, K117 and L127. There have been some reports of Thy1 monoclonal antibodies cross reacting with some cytoskeletal elements: anti Thy-1.2 with actin in marsupial, murine, and human cells and anti Thy-1.1 with vimentin, and were suggested to be due to sequence homology by studies done more than 20 years back. Thy-1, like many other GPI anchored proteins can be shed by special types of Phospholipase C e.g. PI-PLC (phosphatidyl-Inositol Phospholipase C, or PLC β). it can also be involved in cell to cell transfer of GPI anchored proteins like CD55 and CD59.
The influence of LSD in the realms of music and art became pronounced in the 1960s, especially through the Acid Tests and related events involving bands like the Grateful Dead, Jefferson Airplane, and Big Brother and the Holding Company. San Francisco-based artists such as Rick Griffin, Victor Moscoso, and Wes Wilson contributed to this movement through their psychedelic poster and album art. The Grateful Dead, in particular, became central to the culture of "Deadheads", with their music heavily influenced by LSD. In the United Kingdom, Michael Hollingshead, reputed for introducing LSD to various artists and musicians like Storm Thorgerson, Donovan, Keith Richards, and members of the Beatles, played a significant role in the drug's proliferation in the British art and music scene. Despite LSD's illegal status since 1966, it was widely used by groups including the Beatles, the Rolling Stones, and the Moody Blues. Their experiences influenced works such as the Beatles' Sgt. Pepper's Lonely Hearts Club Band and Cream's Disraeli Gears, featuring psychedelic-themed music and artwork. Psychedelic music of the 1960s often sought to replicate the LSD experience, incorporating exotic instrumentation, electric guitars with effects pedals, and elaborate studio techniques. Artists and bands used instruments such as sitars and tablas and employed studio effects such as backward tape, panning, and phasing. Songs such as John Prine's "Illegal Smile" and the Beatles' "Lucy in the Sky with Diamonds" have been associated with LSD, although the latter's authors denied such claims.
== Desorption mass spectrometry matrix == In mass spectrometry this compound is often abbreviated as "3-NBA" or "m-NBA." It has been used as a liquid matrix for fast atom bombardment and matrix-assisted laser desorption ionization. In electrospray ionization 3-NBA is doped into low surface tension spray solvents to increase analyte charging.
In December 2012, the U.S. state of Washington became the first state to officially legalize cannabis in a state law (Washington Initiative 502) (but still illegal by federal law), with the state of Colorado following close behind (Colorado Amendment 64). On 1 January 2013, the first cannabis "club" for private marijuana smoking (no buying or selling, however) was allowed for the first time in Colorado. The California Supreme Court decided in May 2013 that local governments can ban medical cannabis dispensaries despite a state law in California that permits the use of cannabis for medical purposes. At least 180 cities across California have enacted bans in recent years. On 30 April 2024, the United States Department of Justice announced it would move to reclassify cannabis from a Schedule I controlled substance to the somewhat less restricted Schedule III. On 18 December 2025, Donald Trump signed an executive order to reclassify cannabis as a Schedule III drug. In December 2013, Uruguay became the first country to legalize growing, sale and use of cannabis. After a long delay in implementing the retail component of the law, in 2017 sixteen pharmacies were authorized to sell cannabis commercially. On 19 June 2018, the Canadian Senate passed a bill and Prime Minister Justin Trudeau announced the effective legalization date as 17 October 2018. Canada is the second country to legalize the drug. In November 2015, Uttarakhand became the first state of India to legalize the cultivation of hemp for industrial purposes.
Sources: en.wikipedia.org
Sealed lyophilised powder is normally kept at minus twenty degrees Celsius or below, away from light and moisture. Vials are allowed to reach room temperature before opening to limit condensation. Repeated warming and cooling of the same vial is discouraged.
Reversed-phase HPLC establishes purity and separation from related peptides, and mass spectrometry confirms the molecular mass. Amino acid analysis can verify residue composition. No single method proves identity on its own, so the results are read together.
Yes. Residual trifluoroacetate or acetate from purification adds mass and can shift the value obtained by certain assays. Purity figures are therefore meaningful only when the counterion form is stated. Reporting both peptide content and salt form gives a clearer picture.
Epitalon is a synthetic tetrapeptide built from four amino acids: alanine, glutamate, aspartate, and glycine. It is not extracted from a natural source but made in the laboratory by chemical synthesis. Its short length makes it relatively straightforward to produce at high purity.