electrospray ionisation raises a handful of sensible questions. This page answers them in order, starting with the fundamentals and moving to applications.
Reviewed 2025-09-01. Anything still debated is marked as such rather than presented as settled.
The peptide emerged from research carried out in Saint Petersburg from the late 1980s onward, where investigators searched for shorter active fragments of a pineal preparation known as epithalamin. The name epitalon was chosen to reflect that parent extract. Early reports described effects on neuroendocrine markers and on the lifespan of laboratory animals. Much of that work appeared in Russian-language journals, with English translations following later, which affects how readily the original protocols can be assessed by outside groups.
Published studies on epitalon are dominated by a small number of research groups, and independent replication in other laboratories remains limited. Proposed mechanisms include activation of telomerase and modulation of melatonin rhythms, but the evidence for either rests mainly on cell cultures and animal models. Whether the peptide produces comparable effects in humans is an open question, and the absence of large controlled trials means the literature is best read as exploratory rather than settled.
Epitalon is a synthetic four-amino-acid peptide with the sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9, and its calculated molar mass is approximately 390.35 grams per mole. The compound is a short fragment related to a peptide fraction isolated from bovine pineal gland extracts, and it is normally supplied as a lyophilised powder intended for laboratory research. It is not a registered pharmaceutical product in most countries.
Identity testing for epitalon relies on reversed-phase high-performance liquid chromatography for purity and mass spectrometry for mass confirmation. Because the sequence contains no tryptophan or tyrosine, ultraviolet detection at 280 nanometres is insensitive, so chromatographic methods usually monitor absorbance near 214 nanometres, where the peptide backbone absorbs. Electrospray ionisation or matrix-assisted laser desorption/ionisation then checks the intact mass against the expected value near 390 daltons. Peptide mapping or amino acid analysis after acid hydrolysis can supplement these measurements, although such confirmatory work is seldom reported on commercial certificates of analysis.
Stability of the tetrapeptide follows ordinary peptide chemistry rather than any unusual structural feature. The aspartate-glycine pair is prone to aspartimide formation under mildly basic or neutral conditions, and deamidation can follow, altering both mass and chromatographic retention. Dry lyophilised powder kept at or below minus twenty degrees Celsius is the usual handling recommendation, with repeated freeze-thaw cycles avoided. Once dissolved in neutral aqueous buffer, degradation proceeds over days to weeks depending on pH and temperature, while acidic conditions generally slow the aspartimide route. A formal stability-indicating study has not been published in the indexed literature.
Because epitalon has no pharmacopoeial monograph, quality assessment depends on supplier documentation and independent testing. Certificates of analysis typically report a purity figure from a single chromatographic run, a measured mass and sometimes an appearance description, but methods and acceptance criteria are not harmonised across vendors. Third-party laboratories can repeat identity and purity measurements, and mismatches between labelled and measured peptide content have been described for research peptides generally. What constitutes adequate identity confirmation for a molecule of this size stays an open question, since mass agreement alone does not separate closely related sequences.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C14H22N4O9 | Derived from the four-residue sequence |
| Molar mass | About 390.35 g/mol | Free peptide, counter-ion not included |
| Appearance | White to off-white powder | Lyophilised solid from aqueous solution |
| Water solubility | Freely soluble | Short, polar peptide chain |
| Common synonyms | AEDG; epithalone | Catalogues use the names interchangeably |
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. It was designed at the St. Petersburg Institute of Bioregulation and Gerontology as a short, chemically defined analogue of epithalamin, a fraction obtained from bovine pineal tissue. Small peptide bioregulators of this type formed a long-running line of work there from the 1980s onward. Because the molecule is produced by solid-phase synthesis rather than extraction, its composition is exact and its purity can be measured directly.
The most frequently cited proposed action is induction of telomerase, the enzyme that adds repeat sequences to chromosome ends. Cell-culture work from the originating group reported higher telomerase reverse transcriptase expression and measurable telomere elongation in human somatic cells after exposure. How a four-residue peptide would reach nuclear gene regulation is not established, and no cell-surface receptor or uptake route has been identified. Additional reports describe changes in melatonin secretion, antioxidant enzyme activity and lipid peroxidation in aged animals, but these findings remain mechanistically unconnected to the telomerase observation.
Published evidence comes mainly from Russian-language journals and from a single research group, with small sample sizes and limited independent replication. A few laboratories outside that group have examined related peptides and reported weaker or absent telomerase effects, so the central claim is best described as contested rather than settled. Rodent studies report modest changes in some ageing markers and in survival, but designs vary and control conditions are often sparse. No large randomised trial in humans has been published, and long-term safety data in healthy populations are correspondingly thin.
The molecule is a short, linear, hydrophilic peptide that dissolves readily in water or aqueous buffer. Its principal chemical liabilities are hydrolytic rather than oxidative, since it contains no cysteine, methionine, or tryptophan residues. The aspartate–glycine step is a recognised site for aspartimide formation under mildly acidic or basic conditions, generating isoaspartate and succinimide-related products over time. Desiccated lyophilised powder held at −20 °C is comparatively stable, whereas dilute solutions degrade faster and are best frozen as single-use aliquots rather than thawed repeatedly.
No pharmacopoeial monograph exists for this peptide, so quality rests on the supplier's internal specifications and on whatever independent testing a purchaser arranges. Certificates of analysis differ widely in which tests they report and in the limits applied. The counter-ion introduced during purification, commonly acetate or trifluoroacetate, changes the net peptide content of a given mass of powder, so two samples of equal weight may not contain equal amounts of the active sequence. Third-party laboratories can verify purity, identity, residual solvents, and counter-ion content for a fee, which makes documentation more informative than labelling.
Epitalon is a synthetic tetrapeptide whose four residues are alanine, glutamate, aspartate and glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9 and its monoisotopic mass is near 390.35 daltons. The peptide carries two acidic side chains, so it is neutral to negatively charged in most aqueous buffers. Published reference summaries usually list it under both spellings, epitalon and epithalon, and treat the two names as the same material.
The compound is generally described as a synthetic analogue of a fragment isolated from a pineal gland extract. Researchers associated with the Saint Petersburg Institute of Bioregulation and Gerontology introduced it during the 1980s and 1990s while studying short peptides from animal tissue. The original extract, called epithalamin, is a heterogeneous mixture, whereas epitalon is a single defined sequence. That distinction matters because findings reported for the extract are not automatically findings about the pure tetrapeptide, and claims about broader biological effects remain a separate question from the chemical identity described here.
Residue composition is the property that most cleanly separates verified material from mislabelled samples. Alanine, glutamate, aspartate and glycine appear in that order from the N-terminus, and the two acidic residues sit in the middle of the chain. Because the peptide is short, it can be produced by solid-phase synthesis and characterised by mass spectrometry without ambiguity. Any reported sample whose measured mass departs substantially from 390 daltons is a different compound or a degraded mixture rather than epitalon.
For many years, exobiologists have proposed the existence of a shadow biosphere, a postulated microbial biosphere of Earth that uses radically different biochemical and molecular processes than currently known life. One of the proposals was the existence of lifeforms that use arsenic instead of phosphorus in DNA. A report in 2010 of the possibility in the bacterium GFAJ-1 was announced, though the research was disputed, and evidence suggests the bacterium actively prevents the incorporation of arsenic into the DNA backbone and other biomolecules.
There have been a variety of long-overlap-based assembly methods developed in recent years. One of the most commonly used methods, the Gibson assembly method, was developed in 2009, and provides a one-pot DNA assembly method that does not require the use of restriction enzymes or integrases. Other similar overlap-based assembly methods include Circular Polymerase Extension Cloning (CPEC), Sequence and Ligase Independent Cloning (SLIC) and Seamless Ligation Cloning Extract (SLiCE). Despite the presence of many overlap assembly methods, the Gibson assembly method is still the most popular. Besides the methods listed above, other researchers have built on the concepts used in Gibson assembly and other assembly methods to develop new assembly strategies like the Modular Overlap-Directed Assembly with Linkers (MODAL) strategy, or the Biopart Assembly Standard for Idempotent Cloning (BASIC) method.
The tree was created by maximum likelihood analysis without bootstrap: consequently accuracy is traded off for size and many phylum level clades are not correctly resolved (such as the Firmicutes). (Eukaryotes not present in analysis). This phylogeny is a summary of the 16S rRNA based LTP_07_2026 and contains all type species with validly published names up to July 2026. Branching order of bacterial phyla (Woese, 1987) Branching order of bacterial phyla (Gupta, 2001) Branching order of bacterial phyla (Cavalier-Smith, 2002) Branching order of bacterial phyla (Rappe and Giovanoni, 2003) Branching order of bacterial phyla (Battistuzzi et al., 2004) Branching order of bacterial phyla (Ciccarelli et al., 2006) Branching order of bacterial phyla (Genome Taxonomy Database, 2018) Bacterial phyla List of Archaea genera List of bacteria genera List of bacterial orders LPSN, list of accepted bacterial and archaeal names http://www.arb-silva.de/projects/living-tree/
Sources: en.wikipedia.org
Bodybuilders may supplement their diets with protein for reasons of convenience, lower cost (relative to meat and fish products), ease of preparation, and to avoid the concurrent consumption of carbohydrates and fats. Additionally, some argue that bodybuilders, by virtue of their unique training and goals, require higher-than-average quantities of protein to support maximal muscle growth. While the recommended dietary allowance is much less, Harvard Medical School points out in Harvard Health Publishing that this RDA (recommended daily allowance) is “the minimum amount you need to keep from getting sick — not the specific amount you are supposed to eat every day.” Protein supplements are sold in ready-to-drink health shakes, bars, meal replacement products (see below), bites, oats, gels and powders. Protein powders are the most popular and may have flavoring added for palatability. The powder is usually mixed with water, milk or fruit juice and is generally consumed immediately before and after exercising or in place of a meal. The sources of protein are as follows and differ in protein quality depending on their amino acid profile and digestibility:
The method numbers generally range from 1 to 9000 and may have modification letters appended to the end, signifying a newer version of the method has been released. Some ranges of numbers appear to be organized with intention, for example methods 1-99 being air methods or the 7000s being for hazardous waste. Others number ranges, however, seem to only contain random methods, like the 300 and 400 series both being for wet chemistry methods. EPA methods are listed by category on the EPA website. The US government keeps a collection of environmental testing methods at the National Environmental Methods Index website which includes EPA methods along with methods from other agencies like the USGS. Analytical chemistry EPA Hazardous Waste Test Methods EPA Air Emission Methods with Links Clean Water Act Analytical Methods Drinking Water Analytical Methods
The tine test, which uses a "button" with four to six short needles coated with tuberculin instead of an injection. It is easier to administer. It has comparable results if "doubtful" indications are treated as positive. The US CDC and the American Thoracic Society believe that it is less reliable because the amount of tuberculin that enters the skin cannot be accurately determined, despite the aforementioned results. The Heaf test, a test similar to the tine test formerly used in the United Kingdom. A spring-loaded instrument with six needles is used. It stopped being used in 2005 as the manufacturer deemed the production of this instrument financially unsustainable.
Sources: en.wikipedia.org
It is a synthetic tetrapeptide built from alanine, glutamate, aspartate and glycine. The four residues are joined by standard peptide bonds, giving a linear chain rather than a branched structure.
The name derives from epithalamin, a pineal gland extract studied in the former Soviet Union. Researchers proposed that short fragments of that extract carried the biological activity of interest.
No major regulatory agency has approved it as a medicine. It is handled as a research chemical, and products sold under this name are not standardised drugs with defined clinical labelling.
The molecule lacks aromatic residues, so it absorbs weakly near 280 nanometres, the wavelength applied to many other peptides. The peptide bond absorbs strongly below 220 nanometres, making 214 nanometres a practical compromise. Gradient methods must therefore use mobile phases with low ultraviolet absorbance to keep the baseline clean.